Support us on Patreon: https://www.patreon.com/woodshoplife
1)Wanted to start out by saying thank you for making my 30 min drive to and from work some of the most enjoyable and informative time of my day. My question is regarding lumber storage; I have a small one car garage shop that has a slight twist from the norm. Though it is a “garage” it is built over a basement and has a thick wooden floor. The basement space is unused and is connected to the basement of the house via a door. Do you guys think the atmospheric conditions in the basement would differ enough from the above garage space as to cause issues if I used it for my lumber storage area. My shop is well organized but pretty tight. I’ll have storage in the shop for smaller wood and I have a dedicated shelve system under my miter saw station to store all the parts for a single project minus larger sheet goods. I want to use the basement to keep 200-300 board feet to allow it to acclimatize to my shop. Side note, the basement space under the garage has a small garage door for lawnmower storage so air transfer will be similar to the garage above.
I know Guy I’ll comment so here is the answer, no I don’t park my car over the basement on the wooden floor. Thanks guys and keep up the great work. Brian
2) Hey guys, love the podcast. You guy’s, all, have jointer/planers with carbide cutter heads. What kind of finish are you getting with these? Is scraping or sanding still needed for a final finish, or are your parts ready for finish? Are these cutter heads, all they are cracked up to be? Ken
1) Thanks the great podcast! I’ve been catching up on them recently; not quite all the way though. Haven’t heard Guy use ‘specificity’ for a while, so if you could see to that I’d appreciate it! 😉
This question is about pocket hole joints and the need for glue – or not. Given that pocket hole joints most commonly involve butt joints, i.e. short grain to long grain, is it really worth adding glue to the mix? Part of me wonders whether with plywood having alternating grain direction to the layers might offset that a little? I realize that it probably doesn’t hurt anything in the long run, but it seems like it just makes everything more slippery and difficult to align. What are your thoughts on this? Thanks and keep up the good work, Monte
2) I’m interested in what you’d recommend for a beginner-friendly spray finish setup for occasional use on projects ranging from small boxes on up to possibly cabinets – if it’s even feasible for one setup to cover that kind of range. If not, what would you recommend for one vs. the other. Thanks and keep up the great work, Monte
1) So it seems every time I install hinges there is some issue with them, whether it’s a lid not closing flush, a door that swings open, or spacing around a door not being consistent. I will qualify that I rarely if ever use “quality” hinges. I’m more likely to use home center or the cheaper Rockler/Woodcraft options.
Can you give any advice on having the best success with hinges? Both by hand and using power tools, please. I consider myself a decent woodworker but this continues to be an issue for me. Peter
2) I have been binge listening to your podcasts for the last several weeks and I am loving it. I love the format (especially compared to the other podcasts out there). I have learned a lot from listening to you as a new wood worker. I finally found and went to a hardwood dealer near me and bought some beautiful 5/4 and 8/4cherry. I put it on my lumber rack to acclimate to my shop. They are on a Bora horizontal rack. Do you recommend sticking them to allow air flow all around or should I just
stack one on top of the other? I look forward to your next show and hopefully I make it.